11/20/2023 0 Comments Wiring a light switch![]() ![]() length of bare ground wire, fasten it around the green screw terminal, and tighten the screw snugly. Make an open-ended loop on the black wires with needle-nose pliers or wire strippers. Then connect the Phase, Neutral and Earth wires of the flexible wire of the Lamp holder to the Ceiling rose to correspond to the L,N and E respectively. Strip each wire’s insulation back about 3/4 in. The general rule for electrical wire color codes is that the red and black wires will be. Normally the Earth wire is used for a Lamp fitting with metal parts to be connected. Remove the switch from the wall and label the wires connected to it. /rebates/&252farticle252flight-switch-wiring-diagram. If the holder is Screw type, then the Neutral should be connected to the threaded part of the terminal and the Phase to the other terminal. If the holder is a pin type one, then either the Phase or the Neutral can be connected to any terminal. The way a light switch is wired depends on whether the power comes into the light box or the switch box first. Twist another wire connector onto the bare. Take the lamp holder and a short length of 3 core flexible cable and connect the Phase and Neutral wires to the holder. Twist the black wire from the switch box to the black wire from the light fixture with another orange wire connector. ![]() Now all the 3 terminals of the Ceiling rose are connected. You can see here that there are two brown wires that are wired into the switch and if. Draw these Neutral and Earth wires directly to the ceiling rose and use the two spare terminals to connect these wires separately. Carefully remove the two retaining screws and pull the switch forwards. It is good practice to number the Phase and the Neutral wires at the DB for easy identification as one circuit.Ĭonnect the Earth wire to the Earth link provided in the Distribution Board. ![]() Draw the Phase wire to the Switch box and connect to one terminal.Ĭonnect another Phase wire to the remaining terminal of the switch and draw it to the Ceiling Rose position and connect to one of the 3 terminals of the Ceiling rose.Ĭonnect the Neutral wire to the Neutral Link provided in the DB. Make sure that the Power is isolated to the Distribution board or any circuit you will be working with.Ĭonnect the Phase wire to the outgoing side of a 6A or a 10A MCB from the Distribution Board. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |